• Aesthetics – Available in specify shades.
• Easy to use – Easily to mix with water and forms soft consistency paste which is easy to fill the joints.
• Shrinkage & cracking – Avoids cracks formation in the joints and also there is negligible shrinkage.
• Service Temperature – Specially formulated for temperature range of 5° – 120°C.
• Water resistant – Excellent water-resistance making it beneficial for application in areas immersed under water.
• Durability & UV resistant – Excellent UV resistance & durability enables the product use for exterior application.
• High Strength & abrasion resistant – High strength & abrasion resistance properties makes it suitable for grouting of toilets & bathrooms.

Cleaning brickwork :

• A small trial area should be cleaned first to determine the most suitable TILE CLEANER cleaning agent dilution. Pre-wet the brickwork, then using a sponge, rub the affected areas with a soluon of TILE CLEANER cleaning agent and water.
• Strength of the solution required will vary but should be between 1:1 and 1:4 (by volume of TILE CLEANER cleaning agent to water). When the acon has finished, wash down thoroughly with clean water.

Cleaning large items of equipment :

• E.g. Ready mix trucks, concrete mixers, barrows, etc. TILE CLEANER cleaning agent should be liberally applied to the deposits by a so broom and allowed to soak overnight if possible.
• . If the surfaces of the deposit can be cracked by mechanical means this will speed up the operaon In severe cases more than one application may be necessary.
• On completion, dissolved deposits and loose material should be wire brushed and washed away with clean water.

Cleaning small tools :

• Use TILE CLEANER as a dip. The tools should be soaked overnight, then taken out and washed with clean water to remove all loosely adhering materials.
• Care should be taken to avoid prolonged contact between TILE CLEANER and zinc or aluminum parts of tools, e.g. rivets, etc.

Cleaning concrete floors :

• Pre-wet the floors, then using a sff bristle broom, brush the affected areas with a soluon of TILE CLEANER and water. 
• Strength of the soluon required will vary but should be between 1:1 and 1:4 (TILE CLEANER cleaning agent to water).When the acon has finished, wash down thoroughly with clean water.

Removal of rust and mill scale :

• Pre wet the floors, then using a sff bristle broom; brush the affected areas with a soluon of TILE CLEANER and water. Strength of the soluon required will vary but should be between 1:1 and 1:4 (TILE CLEANER to water).
• When the acon has finished, wash down thoroughly with clean water. Wire brush again to remove remaining loose material and finish by thoroughly washing down with clean water.
• Repeat if necessary. High degree of rust or scale can be removed by soaking in the TILE CLEANER solution for 60 minutes.

Etching concrete floors :

• For etching surfaces to remove laitance and give a mechanical key before applying resin or other coang, TILE CLEANER cleaning agent should be diluted with water and applied at the rate of approximately 2 1 liter/2 M2.
• The dilution will depend upon the condion of the floors and the degree of etching required, but normally it will be between 1:2 and 1:4. When the action has finished, wash down thoroughly with clean water.

Health & Safety :

• TILE CLEANER cleaning agent is acid based and should be handled with care.
• It aacks zinc, aluminum and putty. If in doubt about its effect on a material, test a small area before application.
• Avoid contact with skin. Rubber gloves and goggles should be worn.
• Wash spillages with plenty of water. Enclosed areas should be well ventilated.
• If contact with eyes, wash immediately with water and seek medical advice.